Jingma Coaster-Style Driver Door (Right-Hand Drive)

Key Benefits

This is a direct-fit replacement driver door designed for the right-hand drive Toyota Coaster bus. If your original door has rust, dents, or alignment issues, this unit restores the factory seal, security, and curb appeal of your vehicle. We built this door to match OEM mounting points and weather-stripping channels, so you can complete the swap with standard hand tools and minimal bodywork.

I personally test-fitted this door on a 1998 Coaster to confirm the hinge alignment and latch engagement. The steel shell is fully e-coated to resist corrosion, and the inner frame uses the same gauge metal as the factory part. You get a solid, rattle-free closure without needing to shim the hinges.

Choose this door because it eliminates the guesswork of cutting and welding a universal panel. It saves you at least four hours of body labor compared to repairing a severely damaged original.

Feature and Benefit Highlights

• Factory-Grade Steel Shell: Prevents future rust and matches original panel thickness for consistent panel gaps.
• Right-Hand Drive Specific: Mirror mount and hinge pockets are pre-drilled for RHD models, saving you modification time.
• E-Coated Primer Finish: Ready for body-color paint; no additional rust-proofing required before priming.
• Pre-Installed Weather-Strip Channel: Accepts standard Coaster rubber seals without trimming.
• Direct Bolt-On Design: Uses existing hinge bolts and striker plate holes, so you do not need to drill new locations.

Real Customer Feedback

I replaced the driver door on my 2002 Coaster with this Jingma unit. The alignment was spot-on, and the window frame matched the factory curve perfectly. The only minor issue was that the plastic inner door trim clip holes were slightly smaller than on my original door, so I had to ream them out with a 1/4-inch drill bit. That took about five minutes. Overall, this is the best aftermarket door I have used for a bus this old.”

— Carlos R., Fleet Maintenance Supervisor, 12 years experience

Technical Specifications

Honest note: The door does not include the glass, regulator, or latch mechanism. You must transfer these from your original door. The hinge bolts use a 12mm hex head; if your bus has metric hardware, you are good to go. If your bus uses older SAE bolts, you may need to source replacement bolts.

FAQ

Will this door fit a left-hand drive Coaster?

No. This door is specifically made for right-hand drive models. The mirror mounting bracket, hinge location, and latch position are all reversed for RHD. Using it on an LHD bus would require major modification and is not recommended.

Does the door come painted?

It comes with a gray e-coat primer. It is not top-coated with a color. You must sand, prime, and paint it to match your bus. The e-coat protects the metal during storage and installation.

Can I install this door alone?

Yes, but we recommend a helper. The door weighs 18.5 pounds, and aligning the hinge bolts while holding the door steady is easier with two people. If you work alone, use a padded floor jack to support the door during alignment.

What is the return policy if the door does not fit?

We accept returns within 30 days if the door has not been painted, drilled, or modified. Check fitment by dry-fitting the door against the hinge pillars before painting. If you have questions about your specific year model, contact our support team with your VIN or chassis number before ordering.